MACHINING OPERATIONS ARE LOUD ("CHATTERY")
Cause:Incorrect pull stud used for the machine.
Probability How-To Steps
Low Verify that all pull studs used in the machine are of the appropriate type.
NOTICE! You must only use BT30-45° (ISO7388-3-JF30-45) type pull studs with
this machine (Pull Stud, BT30-45° (PN37553)). Other pull stud types or
angles can cause damage to the pull stud clamping mechanism.
If you find incorrect pull studs used in the machine, inspect the clamping
mechanism for damage. If you find any damage, replace it with Clamping Unit,
BT30 (PN 39690).
Page 43
©Tormach® 2021
Specifications subject to change without notice.
tormach.com
TD10705: Installation Guide: BT30 Spindle Upgrade Kit for 1100M+ (0521A)
To Next Page
Loading...
General