Instructions for Use TORMAX 2101 T-1672 e 5
2 Safety
2.1 Responsibilities
For instructing the operator: A skilled person from a TORMAX sales partner
For operating the system: The operator or a person instructed by the operator
For maintenance and function control: The operator or a person instructed by the operator
For annual testing and approval: A skilled person authorised by the manufacturer
Skilled persons are persons who have adequate knowledge in the field of power-operated doors as a
result of their specialist training and experience and who are so familiar with the relevant health and
safety regulations, guide-lines and generally recognised codes of practice that they are able to assess
the condition of power-operated doors with regard to the safety of their operation.
Maintenance of electrical parts must be carried out by a trained electrician.
2.2 Intended Use
The automatic sliding door is intended exclusively for use in dry premises in areas used as a pedes-
trian thoroughfare. The manufacturer will not accept any liability whatsoever for loss or damage caused
by improper use, failure to comply with the maintenance specification (see section 6) or unauthorised
modification of the system.
2.3 Pre-conditions for the Operation of the System
The door system was designed, installed and checked for functionality and safety by skilled persons
prior to hand-over to the operator. The company responsible for the system’s installation instructed the
operator on the system’s use and maintenance as well dangers associated with the system operation.
The operator has confirmed this by his signature in the system test book T-879.
The provisions imposed by law, health and safety and occupational health regulations for the avoidance
of accidents and the protection of the environment which are generally applicable in the country in
which the system is operated supplement the Instructions for use.
• Read the Instructions for use carefully before commissioning the automatic sliding door.
• Only use the system when it is in perfect working order. The operating conditions, inspection
and maintenance intervals stipulated by the manufacturer must be observed (section 6).
• Safety facilities (e.g. sensor technology, manual unlocking) must not be removed or disabled.
• Arrange to have any faults rectified immediately by a skilled person.
2.4 Hazards and Risks
Depending on the system design and equipment, there is a residual risk of crushing, entanglement and
collision in the movement area of the door leaves – albeit with restricted force.
To Next Page
Loading...
Need help?
General
