Tormax Automatic Win Drive 2201 - Maintenance; Cleaning; Functional Checks; Maintenance and Testing

12 Instructions for Use Win Drive 2201 T-1165 e
6 Maintenance
Thesystemwastestedandapprovedbyanexpertbeforeinitialcommissioning.Themanufacturerrecom-
mends that you conclude a service contract in order to maintain the value of your system for as long as
possible as well as to ensure the system operates reliably and safely for a long time.
Only genuine TORMAX spare part should be used. The manufacturer accepts no liability if you fail to
observe this requirement.
The following maintenance work must be carried out:
6.1 Cleaning
– Closingdoorscancrush–danger!
– Trappedlimbscanleadtoseriousinjury.
– ThesystemmustonlybecleanedinoperatingmodeOFF,OPENorManualOperation.
• Cleancasingparts,theuserinterfaceanddoorleaveswithadampclothandacommercialcleaner.
• Removedirtfromtheoorguideandcleanwithadampcloth.
6.2 Functional Checks
The operator must check the function and safety devices of the automatic sliding door at least every
3 months. This will ensure that faults or hazardous changes in the system are detected at an early
stage. See section 7.2 “Check-list for Functional Checks” for items to be checked.
You should arrange for any defects detected during the routine checks to be rectified immediately by a
TORMAX dealer (see the last page of this Manual for the address).
– Potentialswitchingmalfunctionintheautomaticslidingdoor.
– Potentialhazards–injurycausedbyimpactorcrushing.
– Donotuseanypartof yourbodyforfunctionalchecks.Useasuitableobject(e.g.styro-
foam or cardboard) instead.
6.3 Maintenance and Testing
Maintenance and testing should only be carried out by a trained skilled person following the manufacturer’s
instructions.
Maintenance Interval
The maintenance interval depends on the frequency of use but the system must be maintained at least
once per year.
Scope of the Maintenance Work
The content of the maintenance work is specified by the manufacturer in an inspection list.
System Test Book
The test findings are recorded after the test in the system test book. The operator must keep it in a safe
place.