Tormax iMotion 1301.S Instructions For Use

10 Instructions for Use iMotion 1301/1301.S /1401 T-1305 e
4.3 Operation with an Operating Mode Switch u
Selection of Operating Modes
The switch position defines the operating mode.
T1305_4
OFF
AUTOMATIC 1
OPEN
Resetting the system
– Changetheoperatingmodeintheeventof afault
or
– Cutoffpowersupplytothesystemforatleast5seconds.
4.4 Operation on Power Failure
Opening a Door using a Key Switch u with a Battery Unit u
• Turnthekeyswitchtothe“on”positionandholdinplaceforatleast5seconds,thenturnthekeyto
the original position.
 The battery is activated using the “wake up” function.
The key switch must not remain permanently in the “on” opposition.
 The door is unlocked and opened.
 The battery switches off again after the time programmed
< by the installation engineer or
when the battery is fully discharged.
If required, the operating mode can be changed on the user interface during the wake-up.
4.5 Resetting the Panic Fitting u
• SelectoperatingmodeOFF(operatingmodeswitch, user interface )ordisconnecttheoperator
frommains(installationswitch,mainsplug).
• Pushthedoorleafbackintotheinitialposition.
• ChooseoperatingmodeAUTOMATIC1orswitchonoperator.

Tormax iMotion 1301.S Specifications

General

Brand	Tormax
Model	iMotion 1301.S
Category	Door Opening System
Language	English