12 Instructions for Use iMotion 1301/1301.S /1401 T-1305 e
6 Maintenance
The system was tested and approved by a skilled person before initial commissioning. The manufacturer
recommends that you conclude a service contract in order to maintain the value of your system for as long
as possible as well as to ensure the system operates reliably and safely for a long time.
Only genuine TORMAX spare part should be used. The manufacturer accepts no liability if you fail to
observe this requirement.
The following maintenance work must be carried out:
6.1 Cleaning
– Closingdoorscancrush–danger!
– Trappedlimbscanleadtoseriousinjury.
– ThesystemmustonlybecleanedinoperatingmodeOFF,OPENorManualOperation.
• Cleanthecontrolbox,userinterface,thecoversanddoorleaveswithadampclothandacommercial
cleaning agent.
6.2 Functional Checks
The operator must check the function and safety devices of the automatic swing door at least every
three months. This will ensure that faults or hazardous changes in the system are detected at an
early stage. See section 7.2 “Check-list for Functional Checks” for items to be checked.
You should arrange for any defects detected during the routine checks to be rectified immediately by a
TORMAXdealer(seethelastpageofthisManualfortheaddress).
– Possiblemalfunctionof theautomaticswingdoor.
– Potentialhazards–injurycausedbyimpactorcrushing.
– Donotuseanypartof yourbodyforfunctionalchecks.Useasuitableobject(e.g.styro-
foamorcardboard)instead.
6.3 Maintenance and Testing
Maintenance and testing should only be carried out by a trained skilled person following the manufacturer’s
instructions.
Maintenance Interval
The maintenance interval depends on the frequency of use but the system must be maintained at least
once per year.
Scope of the Maintenance Work
The content of the maintenance work is specified by the manufacturer in an inspection list.
System Test Book
The test findings are recorded after the test in the system test book. The operator must keep it in a safe
place.