INSTALLATION
Recovery Tank Drain
Install the drain door on its mounting hardware. Make sure the
starwheels are tight. Hang the top of the hose on the hose
bracket.
Brushes
1. Raise the brush heads using the switch on
the control panel.
2. Place the brushes or pad holders under
the brush cover. Center the brushes on the
brush couplers. Pull up to lock in place.
3. Check to see that the two solution feed
hoses are connected to their fittings on top
of the brush cover.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
To Next Page
Loading...
Need help?
General