R: Ethernet connector
S: K-Type Thermocouple connector
T: Alarm Bell connector
Warning
After 2 years of service, the Vizitouch battery may become less efficient and could lose the time after a shutdown.
The alarm bell is activated under default faulty conditions and under optional or user defined conditions.
Any of these conditions will energize the alarm bell but may be silenced, except in some cases, by pressing on the
“Alarms / silence” membrane button. When silenced, the alarm bell restarts ringing if a new fault occurs or if the
alarm conditions remain unchanged after 24 hours. The alarm bell automatically stops ringing if alarm conditions
are not present anymore.
Note: other external conditions may trigger optional conditions depending of the factory settings. Verify drawings
affixed inside the cabinet.
Default Conditions :
- IO Cards Communication Loss
- CAN System Failure
- File System Failure
- Alternate Isolating Switch / Circuit Breaker Off / Tripped*
The First Setup must be done prior to using the controller. Completing the First Setup is the only way to access the
homepage and enable the automatic mode of the controller.
To Next Page
Loading...
