Tornatech GPX User Manual

37
Update Program Page
This procedure is highly important and must be attempted with care. Please make sure to contact the factory prior
to using the Update Software function.
Factory Settings
Config > Advanced > Factory Settings
The factory settings are always pre-configured at the factory and set the main parameters of the controller. Most of
the settings found on this page can only be changed by an authorized Tornatech employee and is protected by a
level 8 password.
Automatic Controller – Non-Automatic Controller: An automatic controller will respond to automatic start requests,
like a pressure transducer, a pressure switch, a deluge valve or a remote automatic start trigger. A non-automatic
controller will only start the motor on manual requests.
Pressure Actuated – Non-Pressure Actuated: A pressure actuated controller has at least one pressure transducer
installed and will monitor the system pressure at all time. In an automatic controller, the pressure drop will start the
motor.
Enable/Disable – Ground Fault: The “Ground Fault” is a factory installed option that will enable or disable the
Ground Fault Visual Indication.
“Reset to Factory Settings”: This button redirects to the “Reset to Factory Settings” page. This is a major operation

Tornatech GPX Specifications

General

Brand	Tornatech
Model	GPX
Category	Controller
Language	English