Toro 03675 - Installing the CE Hood Latch; Using the Cutting-Unit Kickstand

5
InstallingtheCEHood
Latch
Partsneededforthisprocedure:
1Hoodlatchassembly
1Washer
Procedure
1.Unlatchandraisethehood.
2.Removetherubbergrommetfromtheholein
theleftsideofthehood(Figure16).
g004143
Figure16
1.Rubbergrommet
3.Removethenutfromthehoodlatchassembly
(Figure17).
g003946
Figure17
1.Hoodlatch3.Rubberwasher
2.Nut4.Metalwasher
4.Outsidethehood,insertthehookendofthe
latchthroughtheholeinthehood.Makesure
thattherubbersealingwasherremainstothe
outersideofthehood(Figure17).
5.Insidethehood,insertthemetalwasheronto
thelatchandsecurewiththenut.Makesure
thatthelatchengagestheframecatchwhenit
islocked.Usetheenclosedhoodlatchkeyto
operatethehoodlatch.
6
UsingtheCutting-Unit
Kickstand
Partsneededforthisprocedure:
1
Cutting-unitkickstand
Procedure
Wheneverthecuttingunithastobetippedtoexpose
thebedknife/reel,propuptherearofthecuttingunit
withthekickstandtomakesurethatthenutsonthe
backendofthebedbar-adjustingscrewsarenot
restingontheworksurface(Figure18).
g003985
Figure18
1.Cutting-unitkickstand
Securethekickstandtothechainbracketwiththe
snapperpin(Figure19).
15