Toro 03676 - Page 17

InstallingtheRearCuttingUnitsto
theLiftArms
CuttingUnitsadjustedfora1.2cm(3/4inch)
orHigherHeightofCut
1.Slideacuttingunitundertheliftarm(Figure25).
g375252
Figure25
1.Cap3.Lift-armyoke
2.Snapperpin4.Carrierframeshaft
2.Assemblethelift-armyokeontothecarrier
frameshaft.
3.Assemblethecaptothepivot-armshaft,and
aligntheholesinthecarrierframeshaft,pivot
armshaft,andcap.
4.Securethepivotarmshaftandcaptothecarrier
frameshaftwiththesnapperpin.
LockingtheCutting-UnitPivotforCutting
GrassonaHillSide—Lockthecutting-unit
pivotstopreventthecuttingunitsfromrotating
downhillwhencuttingacrossthefaceofahill.
Usetheholeinthelift-armpivotshaft(Figure
25)tolockthecuttingunit.Usetheslotfora
steeringcuttingunit.
g375251
Figure26
1.Snap-pinpositions3.Slot(lift-armpivotshaft)
2.Hole(lift-armpivotshaft)
5.Repeatsteps1and2fortheotherrearcutting
unit.
InstallingtheRearCuttingUnitsto
theLiftArms
CuttingUnitsadjustedfora1.2cm(3/4inch)
orLowerHeightofCut
1.Removethelynchpinandwashersecuringthe
tothelift-armpivotshafttotheliftarm,andslide
thepivotshaftoutoftheliftarm(Figure27).
g375236
Figure27
1.Lift-armpivotshaft4.3.Liftarm(rearcuttingunit)
2.Lift-armpivotshaft
4.Washer
2.Assemblethelift-armyokeontothecarrier
frameshaft(Figure28).
17