Toro 03781TE - Adjusting the Support Rollers; Flat Washer (1;4 Inch); Hood-Lock Bracket; Installing the Hood Lock for CE Compliance

1
AdjustingtheSupport
Rollers
NoPartsRequired
Procedure
Dependingonwhatwidthcuttingunitsaretobe
installedonthetractionunit,adjustthesupportrollers
asfollows:
Parkthemachineonalevelsurface,engagethe
parkingbrake,shutofftheengine,andremovethe
key.
•Ifyouareusing27-inchcuttingunits,installthe
rollersintheuppermountingholesofthesupport
assemblychannels(Figure3).
•Ifyouareusing32-inchcuttingunits,installthe
rollersinthelowermountingholesofthesupport
assemblychannels(Figure3).
g019541
Figure3
1.Supportassemblychannel
3.Usethisholefor32-inch
cuttingunits.
2.Usethisholefor27-inch
cuttingunits.
2
InstallingtheHoodLockfor
CECompliance
Partsneededforthisprocedure:
1Hood-lockbracket
2Rivet
1
Screw(1/4x2inch)
2
Flatwasher(1/4inch)
1
Locknut(1/4inch)
Procedure
1.Unhookthehoodlatchfromthehood-latch
bracket(Figure4).
g200373
Figure4
1.Hoodlatch
2.Removethe2rivetssecuringthehood-latch
brackettothehood(Figure5).
12