Toro 04384 - Installing the Roll Bar; Reducing the Tire Pressure

6
AdjustingtheCarrierFrame
Rollers
NoPartsRequired
Procedure
1.Positionthemachineonalevelsurfaceand
lowerthecuttingunitcarrierframestotheoor.
2.Verifythatthereis13mm(1/2inch)clearance
betweenthecarrierframerollersandtheoor.
3.Ensurethatthecarrierframerollersarelevelto
theground.Iftheyarenotlevel,insertalong
toolintotheendofthecarrierframeandapply
pressureuntiltherollersarelevel.
4.Ifyoumustadjusttheclearance,loosenthe
jamnutonthecarrierframestopscrew(Figure
6)androtatethescrewupordowntoraiseor
lowerthecarrierframe.Tightenthejamnutto
securetheadjustment.
g008412
Figure6
1.Carrierframeroller2.Carrierframestopscrew
7
InstallingtheOilCooler
Optional
NoPartsRequired
Procedure
Ifyouareoperatingthemachineinanareawhere
ambienttemperaturesrangefrom20to49°C(70to
120°F),orifyouusethemachineforheavy-dutyuse
(mowingotherareasthangreens,suchasfairwaysor
verticutting),installtheHydraulicOilCoolerKit(Part
No.104-7701)tothemachine.
8
InstallingtheCuttingUnits
Partsneededforthisprocedure:
3
Offsetlifthook(RefertotheCuttingUnitOperator’s
Manualfortheinstallationinstructions)
6
Screw(suppliedwiththecuttingunit)
1
Bolt(#10x5/8inch)
1
Jamnut(#10)
3
Cuttingunit(soldseparately)
6
Ballstud(suppliedwiththecuttingunit)
3
Grassbasket
Procedure
Note:Whensharpening,settingtheheightofcut,
orperformingothermaintenanceproceduresonthe
cuttingunits,storethecutting-unitreelmotorsinthe
supporttubestopreventdamagetothehoses.
Important:Donotraisethesuspensiontothe
transportpositionwhenthereelmotorsarein
theholdersinthemachineframe.Damagetothe
motorsorhosescouldresult.
1.Removethecuttingunitsfromthecartons.
Assembleandadjustthemasinstructedinthe
cuttingunitOperator'sManual.
2.Slidethecuttingunitunderthepullframewhile
hookingthelifthoopontotheliftarm.
12