Toro 04384 - Mounting the Front Carrier Frames; Adjusting the Carrier Frame Rollers

3.Slidethesleevebackoneachballjointreceiver
andhookthereceiverontothecuttingunitball
stud(Figure7).
g021274
Figure7
1.Pulllinkextension3.Balljointreceiver
2.Pullarm
4.Mountthebasketontothecarrierframe.
5.Adjustthepulllinksuntilthereis2to3mm
(1/16to1/8inch)clearancebetweenthelipof
thebasketandthereelblades.Ensurethatthe
basketlipsareequidistantfromthereelblades
allthewayacrossthereelblades.
6.Alignthesocketsintheballjointssotheopen
sideofthesocketiscenteredtowardtheball
stud.Tightenthejamnutstosecurethesockets
inposition.
7.Ensurethatthereisapproximately13mm
(1/2inch)ofthethreadsexposedoneach
reel-drive-motormountingbolt(Figure8).
g008420
Figure8
1.Mountingbolts2.Drivemotor
8.Coatthemotorsplineshaftwithcleangrease
andinstallthemotorbyrotatingthemotor
clockwisesothatthemotorangesclearthe
studs.Rotatethemotorcounterclockwiseuntil
theangesencirclethestuds(Figure8).
9.Tightenthemountingbolts(Figure8).
9
MarkingtheOuterGrass
Baskets
NoPartsRequired
Procedure
Toassistinaligningthemachineforsuccessive
cuttingpasses,dothefollowingproceduretotheNo.
2andNo.3cuttingunitbaskets:
1.Measureinapproximately12.7cm(5inches)
fromtheouteredgeofeachbasket.
2.Eitherplaceastripofwhitetapeorpaintaline
ontoeachbasketparallelingtheouteredgeof
eachbasket(Figure9).
13