Toro 04384 - Installing the Oil Cooler; Installing the Cutting Units

g005115
Figure9
1.Alignmentstrip
3.Cutgrassonright
2.Approximately12.7cm(5
inches)
4.Keepfocalspot1.8to3
m(6to10ft)aheadofthe
machine.
10
AdjustingtheTransport
Height
NoPartsRequired
Procedure
Checkthetransportheight(Figure11andFigure12)
andadjustitifrequired.
1.Parkthemachineonalevelsurface.
2.Oncuttingunitsequippedwithaoffsetlifthook
(Figure10inset),verifythatthedistancefrom
thetopofthecarrierframeadjustingscrewto
thebackofthecarrierframeis25mm(1inch).
Ifthedistanceisnot25mm(1inch),proceed
tostep4.
g008423
Figure10
1.Transportplate
4.Offsetlifthook
2.Adjustingscrew
5.25mm(1inch)
3.Transport-platemounting
screw
3.Oncuttingunitsequippedwithachainlinkor
astraightlifthook(Figure11andFigure12
insets),verifythatthedistancefromthetopof
thecarrierframeadjustingscrewtotheback
ofthecarrierframeis22mm(7/8inch).Ifthe
distanceisnot22mm(7/8inch),proceedtostep
4.Ifthecuttingunitisequippedwithanoffsetlift
link(Figure10),proceedtothenextstep.
g008421
Figure11
1.Transportplate
4.Chainlink
2.Adjustingscrew
5.22mm(7/8inch)
3.Transport-platemounting
screw
14