Toro 2024 - Cleaning Procedures; Cleaning Plastic and Resin Parts

Figure118
1.Drilling-uidvalve(Offposition)
5.Connectthespray-hoseattachmenttothetting
(Figure119).
Figure119
1.Fittingforthespray-hoseattachment(end)
6.Turnthespray-hoseattachmentswitchtotheON
position(Figure120).
Figure120
1.Spray-hoseattachmentswitch(Onposition)
7.Turnthedrilling-uidpumptotheONposition
throughthedisplayscreen;refertotheMainDrill
FunctionsDisplayedinthePressureScreeninthe
SoftwareGuide.
8.Usingthespray-hoseattachment,holddownthelever
andspraydownthemachineandpipes.
CleaningPlasticandResin
Parts
Avoidusinggasoline,kerosene,paintthinner,etc.when
cleaningplasticwindows,theconsole,theinstrumentcluster,
themonitor,gauges,etc.Useonlywater,mildsoap,andasoft
clothwhenyoucleantheseparts.
Usinggasoline,kerosene,paintthinner,etc.tocleanaplastic
orresinpartwillcauseittodiscolor,crack,ordeform.
89