Figure 7
1. Throttle control 5. PTO switch
2. Lift lever 6. Hi-Lo speed control
3. Hour meter
7. Power point
4. Engine temperature gauge
Lift Lever
T he lev er ( Figure 7 ) raises and lo w ers the cutting units .
Hour Meter
T he hour meter ( Figure 7 ) sho ws the total hours that
the mac hine has been operated.
Engine Temperature Gauge
T his g aug e ( Figure 7 ) indicates the engine coolant
temperature .
PTO Switch
T he PTO switc h ( Figure 7 ) has tw o positions: On
(eng ag e) and Off (diseng ag e). Push the PTO switc h
forw ard to the On position to star t the implement or
cutting unit blades . Push the switc h bac kw ard to the
Off position to stop implement operation.
Hi-Lo Speed Control
T he switc h ( Figure 7 ) allo ws the speed rang e to
increase for transpor t of the mac hine . Cutting dec ks
will not operate in high rang e .
Power Point
T he po w er point ( Figure 7 ) is used to po w er optional
12 v olt electrical accessories .
Fuel Gauge
T he fuel g aug e ( Figure 8 ) indicates the lev el of fuel
in the tank.
Figure 8
1. Fuel gauge
Cutting Unit Lift Latch (CE)
T he cutting unit lift latc h ( Figure 9 ) loc ks the center
fiv e cutting unit lift lev ers when the cutting units are in
the raised position.
Figure 9
1. Cutting unit lift latch
17
To Next Page
Loading...
