operation, combined with ter rain angles , ricoc hets ,
or improperly positioned guards can lead to thro wn
object injuries . Do not resume mo wing until the
area is cleared.
Maintenance and Storage
• Mak e sure all h y draulic line connectors are tight and
all h y draulic hoses and lines are in g ood condition
before applying pressure to the system.
• K ee p y our body and hands a w a y from pin hole
leaks or nozzles that eject h y draulic fluid under high
pressure . Use paper or cardboard, not y our hands ,
to searc h for leaks . Hy draulic fluid escaping under
pressure can ha v e sufficient force to penetrate
the skin and cause serious injur y . Seek immediate
medical attention if fluid is injected into skin.
• Before disconnecting or perfor ming any w ork on
the h y draulic system, all pressure in the system m ust
be reliev ed b y stopping the engine and lo w ering the
cutting units and attac hments to the g round.
• Chec k all fuel lines for tightness and w ear on a
regular basis . Tighten or re pair them as needed.
• If the engine m ust be r unning to perfor m a
maintenance adjustment, k ee p hands , feet, clothing,
and any par ts of the body a w a y from the cutting
units , attac hments , and any mo ving par ts .
• T o ensure safety and accuracy , ha v e an A uthorized
T oro Distributor c hec k the maxim um engine speed
with a tac hometer .
• If major re pairs are ev er needed or if assistance is
desired, contact an A uthorized T oro Distributor .
• Use only T oro-appro v ed attac hments and
re placement par ts . T he w ar ranty ma y be v oided if
used with unappro v ed attac hments .
Sound Pressure Level
T his unit has an equi v alent contin uous A-w eighted
sound pressure lev el at the operator ear of 90 dB A,
based on measurements of identical mac hines per
Directi v e 98/37/EC and amendments .
Sound Power Level
T his unit has a guaranteed sound po w er lev el of
105 dB A/1 pW , based on measurements of identical
mac hines per Directi v e 2000/14/EC and amendments .
Vibration Level
Hand-Arm
T his unit does not ex ceed a vibration lev el of 2.5 m/s2
at the hands based on measurements of identical
mac hines per ISO 5349 procedures .
Whole Body
T his unit does not ex ceed a vibration lev el of 0.5 m/s2
at the posterior based on measurements of identical
mac hines per ISO 2631 procedures .
Safety and Instructional Decals
Safety decals and instr uctions are easily visible to the operator and are located near any area of
potential dang er . R e place any decal that is damag ed or lost.
104-0131
1. Read the Operator’s Manual.
93-7275
1. Read the Operator’s Manual.
2. Do not use starting aids.
7
To Next Page
Loading...
