Figure 23
1. Top tting on king pin
• Tie rod ball joints (2) ( Figure 23 )
• King pin bushings (2) ( Figure 23 ). T he top fitting
on the king pin should onl y be lubricated
ann uall y (2 pumps).
• Lift ar m bushings (1 per dec k) ( Figure 24 )
Figure 24
• Lift cylinder bushings (2 per dec k) ( Figure 24 )
• Cutting unit spindle shaft bearings (1 per cutting
unit) ( Figure 25 )
Figure 25
• Cutting unit car rier ar m bushings (1 per cutting
unit) ( Figure 25 )
• R ear roller bearings (2 per cutting unit) ( Figure 26 )
Note: T he flush fittings on the rollers ( Figure 26 )
require a g rease gun nozzle adapter . Order T oro
P ar t No . 107-1998 from y our A uthorized T oro
Distributor .
Figure 26
Engine Maintenance
Servicing the Air Cleaner
Chec k the air cleaner body for damag e whic h could
cause an air leak. R e place if damag ed. Chec k the whole
intak e system for leaks , damag e or loose hose clamps .
Ser vice the air cleaner filter only when the ser vice
indicator ( Figure 27 ) requires it. Changing the air filter
before it is necessar y only increases the c hance of dir t
entering the engine when the filter is remo v ed.
33
To Next Page
Loading...
