Premaintenance
Procedures
Removing the Hood
T o g ain additional access to engine compar tment, the
hood ma y be remo v ed from traction unit.
1. R elease hood latc hes ( Figure 19 ) and raise hood.
Figure 19
1. Hood latch
2. Unhook lanyard from hood pin, remo v e pin and
slide hood tubes rearw ard off guides ( Figure 20 ).
Figure 20
1. Hood pin
Lubrication
Greasing the Bearings and
Bushings
T he mac hine has g rease fittings that m ust be lubricated
regularly with No . 2 General Pur pose Lithium Base
Grease . If the mac hine is operated under nor mal
conditions , lubricate all bearings and bushings after
ev er y 50 hours of operation or immediately after ev er y
w ashing .
T he g rease fitting locations and quantities are as
follo ws:
• Brak e shaft pi v ot bearings (5) ( Figure 21 )
Figure 21
• R ear axle pi v ot bushings (2) ( Figure 22 )
Figure 22
• Steering cylinder ball joints (2) ( Figure 23 )
32
To Next Page
Loading...
