GROUND DRIVE & TINE SYSTEMS
5-12
Toro 30” Aerator Service Manual
5
2. Install the outer ange bearing and jack shaft plate.
Re-install the bolts and tighten them to 30 ft-lbs
(41 Nm) (Fig. 212).
Fig. 212 brg & plate inst
Jackshaft Installation
1. Reinstall the shaft into the two bearings on the
chassis. Be sure to include any spacers (A) that
were included (Fig. 211).
Fig. 210 jackshaft
Fig. 211 shaft install
14. Slide the jack shaft out of the remaining bearings
(Fig. 210).
A
To Next Page
Loading...
