SPECIFICATIONS & MAINTENANCE
2-15
Toro 30” Aerator Service Manual
2
4. Allow the control levers to return to neutral. Remove
the spring clevis pin on the turnbuckle of the motion
control linkage. Rotate the turnbuckle clockwise (as
viewed from the top of the machine). Reinstall the
spring clevis pin and move the control lever forward.
Repeat this step until there is minimal gap or contact
between the control lever and the front reference
bar.
5. Remove the spring clevis pin, rotate the turnbuckle
clockwise one more full turn.
6. Reinstall the spring clevis pin. Rotate locknut against
the turnbuckle.
7. Repeat steps 3 through 6 for other motion control
linkage.
Fig. 007 g. 20 G020223
A. Spring clevis pin C. Turnbuckle
B. Locknut
Controls System Maintenance
Motion Control Linkage Adjustment
1. Park the machine on a level surface.
2. Shut off engine and wait for all moving parts to stop.
3. Push the control levers all the way forward to the
front reference bar.
• If the control levers contact the reference bar,
allow the control levers to return to neutral.
Remove the spring clevis pin on the turnbuckle of
the motion control linkage. Rotate the turnbuckle
counterclockwise (as viewed from the top of the
machine). Reinstall the spring clevis pin and
move the control lever forward (Fig. 007). Repeat
this step until there is a gap between the control
lever and the front reference bar. Once the gap is
achieved, proceed with step 4.
• If the control levers do not contact the reference
bar, then proceed to step 4.
A
B
C
To Next Page
Loading...
