CHASSIS
3-16
Toro 30” Aerator Service Manual
3
Motion Control Linkage Adjustment
1. Park the machine on a level surface.
2. Shut off engine and wait for all moving parts to stop.
3. Push the control levers all the way forward to the
front reference bar (Fig. 052).
Fig. 052 012
4. Once there is a minimal gap or contact between
the control lever and front reference bar, remove
clevis spring and rotate the turnbuckle clockwise (as
viewed from the top of the machine) one full turn.
5. Reinstall the spring clevis pin and rotate the locknut
against the turnbuckle.
Note: If the control levers contact the reference
bar, return the control levers to neutral and
remove the spring clevis pin on the turn-
buckle of the motion control linkage. Rotate
the turnbuckle counterclockwise (as viewed
from the top of the machine) (Fig. 053).
Repeat this step until there is a gap between
the control lever and the front reference bar.
Fig. 053 clevis pin
To Next Page
Loading...
