Toro 33518 - Recommended Maintenance Schedule

SPECIFICATIONS & MAINTENANCE
2-5
Toro 30” Aerator Service Manual
2
Recommended Maintenance Schedule
Maintenance Service Interval Maintenance Procedure
After the rst 5 hours • Change the engine oil.
After the rst 100 hours
• Change the auxiliary hydraulic reservoir lter and uid.
• Change the hydraulic transmission lter and uid.
Before each use or daily
• Check the engine oil level.
• Check the safety interlock system.
• Check for loose hardware.
• Lubricate the chains.
• Check the condition and tension of the chains.
• Check the condition of the sprockets.
• Check the tines.
• Clean the engine and exhaust system area.
• Clean the grass and debris build-up from the machine.
Every 25 hours
• Grease the jackshaft bearings.
• Grease the wheel bearings.
• Grease the tine shaft bearings.
• Grease the tine assembly idlers.
Every 50 hours
• Grease the control pivots.
• Check spark arrester (if equipped).
• Check the tire pressures.
• Check the condition and tension of the belts.
• Check the auxiliary hydraulic oil level.
• Check the hydraulic transmission oil level.
Every 80 hours • Remove engine shrouds and clean cooling ns.
Every 100 hours • Change the engine oil. (May need more often under severe conditions.)
Every 160 hours • Check the spark plugs.
Every 250 hours
• Replace the primary air cleaner element - check secondary air cleaner element;
replace if dirty. (May need more often under severe conditions. See the Engine
manual for additional information.)
• Change the auxiliary hydraulic reservoir lter and uid.
• Change the hydraulic transmission lter and uid.
Every 500 hours
• Replace the secondary air cleaner element. (May need more often under severe
conditions. See the Engine manual for additional information.)
Monthly • Check the battery charge.
Yearly
• Grease the front caster pivots.
• Grease the belt idler pivot.
• Lubricate the caster wheel hubs.
• Check the torque of the wheel hub nuts.
• Check the torque on the wheel lug nuts.
• Check the transmission output shaft nut torque specication.
Yearly or before storage • Touch up chipped paint