Why is the Area inaccurate on my Toro 41106 Paint Sprayer?
If the Area on your Toro Paint Sprayer is inaccurate, check and set the appropriate Width in the calibration mode, because the sprayer width might not be correctly entered. Also, calibrate the speed sensor if it is not calibrated correctly. If problems continue, contact your Authorized Service Dealer because the speed sensor might be damaged.
What to do if a boom section does not spray on my Toro Paint Sprayer?
If a boom section of your Toro Paint Sprayer does not spray, you can try the following: * Turn the valve off manually, disconnect the electrical connector on the valve, clean all leads, and then reconnect it, in case the electrical connection on the boom valve is dirty or disconnected. * Check the fuses and replace them as necessary if they are blown. * Repair or replace the hose if it is pinched. * Adjust the boom by-pass valves if a boom by-pass valve is improperly adjusted. * Contact your Authorized Service Dealer if you have a damaged boom valve or damaged electrical system.
Why is the distance reading inaccurate on my Toro Paint Sprayer?
If the distance measurement is inaccurate on your Toro Paint Sprayer, calibrate the speed sensor.
How do I fix inaccurate distance readings on my Toro Sprayer?
If the distance is inaccurate on your Toro Sprayer, calibrate the speed sensor.
What to do if Toro 41106 Paint Sprayer engine cranks, but will not start?
If your Toro Paint Sprayer engine cranks but doesn't start, the fuel tank may be empty, so fill it with fresh fuel. Also, dirt, water, or stale fuel could be in the fuel system, requiring you to drain and flush the fuel system and add fresh fuel. Check for a clogged fuel line and clean or replace it if necessary. Ensure the spark plug lead is connected, and replace the spark plug if it's damaged or dirty.
Why does my Toro 41106 Paint Sprayer abnormal vibration or noise?
If you notice abnormal vibration or noise in your Toro Paint Sprayer, tighten the engine mounting bolts if they are loose.
Why is the monitor on my Toro 41106 operating erratically?
If the monitor on your Toro Paint Sprayer is erratic in operation, keep two-way radios away from the monitor and its cables.
What to do if my Toro Paint Sprayer will not operate in either direction?
If the Toro Paint Sprayer does not operate in either direction, press the brake and shift the range selector into a gear. Also, release the parking brake or check the linkage.
What to do if Toro 41106 Paint Sprayer Total Volume is inaccurate?
If the total volume on your Toro Paint Sprayer is inaccurate, clean the flow meter if it's dirty or clogged. Calibrate the flow meter.
What to do if Toro 41106 monitor does not display Application Rate or Total Volume?
If the monitor on your Toro Paint Sprayer does not display the Application Rate or Total Volume, connect the monitor cable if it's loose. Clean the flow meter if it's dirty or clogged. Calibrate the flow meter.
General| Max Pressure | 3000 PSI |
|---|---|
| Voltage | 120 V |
| Type | Airless |
| Nozzle Size | 0.015 in |
| Power Source | Electric |
To Next Page
