Toro 41594 - Page 62

RemovingtheRateControlManifold
Valve
1.Removeclampsandgasketsthatsecurethemanifold
fortheratecontrolvalve(Figure83).
Note:Retaintheclamp(s)andgasket(s)forinstallation
inInstallingtheRateControlManifoldValve(page67).
Figure83
1.Flange(pressurelter
head)
4.Clamp
2.Manifold(ratecontrol
valve)
5.Gasket
3.Flange(agitationvalve)6.3-pinconnector(valve
actuator—ratecontrol
valve)
2.Removetheretainerthatsecuretheoutletttingtothe
manifoldfortheratecontrolvalve(Figure84).
Figure84
1.Flanged-headbolt4.Retainer
2.Valvemount
5.Socket(outlettting)
3.Flangedlocknut
6.Manifoldvalveassembly
3.Removethe2anged-headboltsand2anged
locknutsthatsecurestheratecontrolvalvetothe
valvemountandremovethevalvemanifoldfromthe
machine(Figure84).
Note:Ifnecessary,loosenedthemountinghardware
forthepressurelterheadtoeaseremovaloftherate
controlvalve..
RemovingtheAgitationManifoldValve
1.Removeclampsandgasketsthatsecurethemanifold
fortheagitationvalve(Figure85)totheagitation
bypassvalve,ratecontrolvalve,masterboomvalve,
andadaptertting(agitationthrottlevalve).
Note:Retaintheclamp(s)andgasket(s)forinstallation
inInstallingtheAgitationManifoldValve(page67).
62