What to do if clutch overcurrent on Toro 74096 Lawn Mower Accessories?
If the clutch current of your Toro Lawn Mower Accessories is above the limit, cycle the key switch to clear the fault. Check the PTO clutch condition and the related wiring. If the issue continues, contact an Authorized Service Dealer.
Why is my Toro Lawn Mower engine losing power?
If your Toro Lawn Mower engine is losing power, consider the following: * Reduce the ground speed. * Clean the air-cleaner element. * Add oil to the crankcase. * Remove any obstructions from the cooling fins and air passages. * Clean or replace the fuel cap. * Replace the fuel filter.
Why is my Toro 74096 Lawn Mower overheating?
If your Toro Lawn Mower engine is overheating, try the following: * Reduce the ground speed. * Add oil to the crankcase. * Remove any obstruction from the cooling fins and air passages.
Why is my Toro 74096 mowing unevenly?
If your Toro Lawn Mower is resulting in an uneven cut, try the following: * Sharpen the blade(s). * Install new cutting blade(s). * Level the mower deck from side-to-side and front-to-rear. * Clean the underside of the mower. * Adjust the tire pressure.
What to do if Toro 74096 Lawn Mower blades do not rotate?
If the blades on your Toro Lawn Mower aren't rotating, here are some things to check: * Check the belt tension. * Check belt for damage; replace if necessary. Install the drive belt and check the belt guide for the correct position. * Install a new deck belt. * Install the deck pulley, idler pulley, idler arm, and spring for correct position and function. * Replace the idler spring. * The engine has overheated; determine the cause of overheating. * Lower the wing decks.
What to do if my Toro 74096 machine does not drive?
If your Toro Lawn Mower machine isn't driving, here are some things to check: * Tighten the by pass valves. * Change the belt. * Replace the spring. * Add hydraulic fluid to reservoirs or let it cool down.
What to do if clutch output fault on Toro 74096 Lawn Mower Accessories?
If the clutch output of your Toro Lawn Mower Accessories has a short or is open, and the clutch is stuck in the ON position, discontinue use and contact an Authorized Service Dealer. Check the clutch connection and associated wiring for an open circuit.
What to do if low oil pressure on Toro Lawn Mower Accessories?
If the engine-oil pressure of your Toro Lawn Mower Accessories is below the limit, cycle the key switch to clear the fault. Check the oil level. If problems persist, contact an Authorized Service Dealer.
What to do if system overvoltage on Toro 74096 Lawn Mower Accessories?
If the system voltage of your Toro Lawn Mower Accessories is excessive (above 16 V), check the battery and engine charging system. If the issue persists, contact an Authorized Service Dealer.
What to do if the engine over temperature on Toro 74096 Accessories?
If the engine temperature of your Toro Lawn Mower Accessories is above the limit, check the oil level, clean any debris from the engine, and inspect the engine fan. If problems persist, contact an Authorized Service Dealer.
General| Start Type | Recoil |
|---|---|
| Deck Material | Steel |
| Engine Type | 4-Cycle |
| Cutting Width | 22 inches |
| Drive System | Rear-wheel drive |
| Oil Capacity | 20 oz |
| Engine | Briggs & Stratton® |
To Next Page
