6-21
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
Table of Contents
DECK
Deck
Belt Replacement (Cont.)
Removal (Cont.)
7. Using a 3/8 in. drive, place the drive into the square hole located on the wing belt idler assembly. Rotate the
idler assembly counter-clockwise to release tension and remove belt (Figure 19).
NOTE: For center belt, use a ½ in. drive and rotate clockwise.
8. Remove the belt.
9. Repeat for opposite side.
10. Remove center belt by rotating idler arm assembly clockwise with ½ drive breaker bar.
NOTE: Plastic belt guards will need to be removed on 60 in. and 72 in. decks.
Figure 19
To Next Page
Loading...
