7-9
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
Table of Contents
DRIVE
Drive
Drive System (Cont.)
Removal (Cont.)
16. Remove the roll pin from the deck drive shaft using a drift punch (Figure 8).
17. Remove the two pinch bolts from the deck drive shaft.
18. Slide the deck drive shaft off the gear box.
19. Disconnect the two main reservoir line hoses.
20. Disconnect the output line to the gear pump (Figure 9).
NOTE: Mark the location of the wheel motor hoses.
Figure 8
Figure 9
To Next Page
Loading...
