Toro 74279TE - User Manual

71 pages

To Next Page

To Next Page

Loading...

FormNo.3400-446RevB

ZMaster

®

Professional7000

SeriesRidingMower

With52inTURBOFORCE

®

RearDischarge

Mower

ModelNo.74279TE—SerialNo.316000001andUp

Registeratwww.Toro.com.

OriginalInstructions(EN)

*3400-446*B

Table of Contents

Questions and Answers:

M
Michael StoneAug 27, 2025
Why won't my Toro Lawn Mower starter crank?
- T
  Theresa BrayAug 27, 2025
  If the starter on your Toro Lawn Mower doesn't crank, there are several things to check. First, ensure the blade-control switch (PTO) is disengaged and the parking brake is engaged. Make sure the drive levers are in the NEUTRAL-LOCK position and that you are seated on the seat. If these are all correct, check the battery to see if it's dead and charge it if necessary. Also, inspect the electrical connections for corrosion or looseness and ensure they have good contact. Finally, check the fuse and replace it if it's blown.
B
Brittany ValentineAug 27, 2025
What to do if my Toro Lawn Mower is resulting in uneven cutting height?
- D
  David NicholsonAug 27, 2025
  If your Toro Lawn Mower is leaving an uneven cut, several factors could be the cause. Start by sharpening the blades or installing new ones if they are bent. Ensure the mower deck is level from side-to-side and front-to-rear. Clean the underside of the mower deck. Adjust the tire pressure to the correct level.
C
Christine GonzalezAug 28, 2025
Why does my Toro 74279TE Lawn Mower engine not start?
- D
  Diana MurphyAug 28, 2025
  If your Toro Lawn Mower engine doesn't start, starts with difficulty, or fails to keep running, you should first fill the fuel tank with fuel. If that doesn't resolve the issue, try cleaning or replacing the air cleaner element, or replacing the fuel filter.
D
Dennis MontgomeryAug 29, 2025
Why won't my Toro 74279TE engine start or keeps dying?
- R
  Richard FloresAug 29, 2025
  Your Toro Lawn Mower engine may not start, start hard, or fail to keep running for several reasons. The fuel tank could be empty, so fill it with fuel. The air cleaner might be dirty, requiring you to clean or replace the air cleaner element. Also, the fuel filter could be clogged with dirt, in which case you should replace the fuel filter.
M
Mr. Christopher MillerAug 31, 2025
Why does my Toro 74279TE engine lose power?
- R
  Rebecca RandolphAug 31, 2025
  If your Toro Lawn Mower engine loses power, the possible causes include: the engine load is excessive (reduce the ground speed); the air cleaner is dirty (clean the air-cleaner element); the oil level in the crankcase is low (add oil to the crankcase); the cooling fins and the air passages above the engine are plugged (remove the obstruction); the vent hole in the fuel cap is plugged (clean or replace the fuel cap); there is dirt in the fuel filter (replace the fuel filter). If the issue persists, there may be dirt, water, or stale fuel in the fuel system, requiring you to contact an Authorized Service Dealer.
M
Ms. Ashley JonesAug 31, 2025
How to fix uneven cutting height on my Toro Lawn Mower?
- J
  juliafisherAug 31, 2025
  If the cutting height of your Toro Lawn Mower is uneven, consider these factors: The blade(s) might not be sharp (sharpen the blade(s)); a cutting blade(s) might be bent (install a new cutting blade(s)); the mower might not be level (level the mower from side-to-side and front-to-rear); an anti-scalp roller (if applicable) might not be set correctly (adjust the anti-scalp wheel height); the underside of the mower deck might be dirty (clean it); the tire pressure might be incorrect (adjust the tire pressure). If the problem persists, a blade spindle might be bent, requiring you to contact an Authorized Service Dealer.
D
Debra ButlerAug 23, 2025
Why is the starter not cranking on my Toro 74279TE Lawn Mower?
- T
  Terri NielsenAug 25, 2025
  If the starter on your Toro Lawn Mower isn't cranking, possible causes include: the blade-control switch may be engaged (disengage it); the parking brake may be disengaged (engage it); the motion-control levers are not in the NEUTRAL-LOCK position (move the motion-control levers outward to the NEUTRAL-LOCK position); you are not sitting in the operator’s seat (sit on the operator’s seat); the battery is dead (charge it); the electrical connections are corroded or loose (check them); a fuse is blown (replace it). If none of these resolve the issue, a relay or switch may be damaged, requiring you to contact an Authorized Service Dealer.
P
Paul ConleySep 2, 2025
Why Toro 74279TE cutting blades do not rotate?
- K
  kinggabrielleSep 2, 2025
  If the cutting blades on your Toro Lawn Mower do not rotate, check the belt tension if the drive belt is worn, loose, or broken. If the drive belt is off the pulley, install the drive belt and check the adjusting shafts and belt guides for correct position. If the mower deck belt is worn, loose, or broken, install a new mower deck belt. If the mower deck belt came off a pulley, install the mower deck belt and check the idler pulley, idler arm, and spring for the correct position and function. If the idler spring is broken or missing, replace the spring.
T
Taylor LopezSep 3, 2025
What to do if my Toro 74279TE blades do not rotate?
- W
  wallsvictorSep 3, 2025
  If the blades on your Toro Lawn Mower do not rotate, check if the mower deck belt is worn, loose, or broken, and install a new deck belt if needed. If the mower deck belt is off the pulley, reinstall it and inspect the idler pulley, idler arm, and spring for correct position and function. Also, inspect the pump drive belt for wear, looseness, or breakage; check the belt tension or install a new belt. Finally, replace the idler spring if it's broken or missing.
T
Timothy ButlerSep 4, 2025
Why is the cutting height uneven on my Toro 74279TE?
- E
  Emily EstradaSep 4, 2025
  If the cutting height is uneven on your Toro Lawn Mower, you can try to sharpen the blade(s) or install new cutting blade(s). Also, level the mower deck from side-to-side and front-to-rear, clean the underside of the mower, and adjust the tire pressure.

Toro 74279TE Specifications

General

Model	74279TE
Self-Propelled	Yes
Deck Material	Steel
Cutting Height	1.0 - 4.0 in (2.5 - 10.2 cm)
Wheel Size (rear)	10 inches
Drive System	Rear Wheel Drive

Related product manuals

Preview: Toro 74274

Preview: Toro 74271

Preview: Toro 74251