Why is the cutting height uneven on my Toro 74279TE?
If the cutting height is uneven on your Toro Lawn Mower, you can try to sharpen the blade(s) or install new cutting blade(s). Also, level the mower deck from side-to-side and front-to-rear, clean the underside of the mower, and adjust the tire pressure.
Why are the cutting blades not rotating on my Toro 74279TE?
If the cutting blades on your Toro Lawn Mower do not rotate, check the belt tension. You may also need to install the drive belt and check adjusting shafts and belt guides for correct position, install a new mower deck belt, install mower deck belt and check the idler pulley, idler arm and spring for the correct position and function, or replace the spring.
Why is my Toro 74279TE Lawn Mower engine losing power?
Your Toro Lawn Mower engine may be losing power due to several factors. The engine load might be excessive, so reduce the ground speed. A dirty air cleaner can also cause this issue, so clean the air cleaner element. Check the oil level in the crankcase and add oil if it's low. Also, ensure the cooling fins and air passages above the engine are free from obstructions. Lastly, the vent hole in the fuel cap could be plugged; try cleaning or replacing the fuel cap. Replacing the fuel filter may also solve the problem.
How to fix Toro 74279TE Lawn Mower when starter does not crank?
If your Toro Lawn Mower starter does not crank, make sure the blade control switch (PTO) is disengaged, the parking brake is set, and the drive levers are in the neutral lock position. Ensure you are seated on the seat. If these steps don't resolve the issue, charge the battery and check the electrical connections for good contact. If the problem persists, replace the fuse. For relay or switch issues, it's best to contact an Authorized Service Dealer.
What to do if Toro Lawn Mower engine loses power?
If your Toro Lawn Mower engine loses power, try reducing the ground speed. Clean the air cleaner element and add oil to the crankcase if the oil level is low. Remove any obstructions from the cooling fins and air passages. Clean or replace the fuel cap if the vent hole is plugged. Replace the fuel filter if it's dirty.
What to do if Toro Lawn Mower blades do not rotate?
If your Toro Lawn Mower blades do not rotate, install a new deck belt. Ensure the mower deck belt is properly positioned on the pulley, checking the idler pulley, idler arm, and spring. Check the belt tension, or install a new pump drive belt. Replace the idler spring if it is broken or missing.
General| Model | 74279TE |
|---|---|
| Self-Propelled | Yes |
| Deck Material | Steel |
| Cutting Height | 1.0 - 4.0 in (2.5 - 10.2 cm) |
| Wheel Size (rear) | 10 inches |
| Drive System | Rear Wheel Drive |
To Next Page
