Toro 74902TE - Adjusting the Motion-Control Damper; Adjusting the Motion-Control Neutral-Lock Pivot

12.Removethejackstands.
13.Raisethedeckandinstalltheheight-of-cutpin.
14.Checkthatthemachinedoesnotcreepin
neutralwhenyoudisengagetheparkingbrakes.
Adjustingthe
Motion-ControlDamper
Youcanadjustthetopdampermountingbolttoobtain
amoredesiredmotion-controlleverresistance.See
Figure87formountingoptions.
g008620
Figure87
Rightmotion-controllevershown
1.Torquethelocknutto23N∙m(17ft-lb).Theboltmust
protrudepasttheendofthelocknutaftertorquing.
2.Mostresistance(rmestfeel)
3.Damper
4.Mediumresistance(mediumfeel)
5.Leastresistance(softestfeel)
Adjustingthe
Motion-Control
Neutral-LockPivot
Youcanadjusttheangednuttoobtainthedesired
motion-controlleverresistancewhenyoumovethem
totheNEUTRAL-LOCKposition.SeeFigure88for
adjustmentoptions.
1.Loosenthejamnut.
2.Tightenorloosentheangednuttothedesired
feel.
Note:Formoreresistance,tightentheanged
nut.
Note:Forlessresistance,loosentheanged
nut
3.Tightenthejamnut.
g008621
Figure88
1.Flangednut2.Jamnut
60