Toro Greensmaster
3150 - Page 48

g229849
g229848
Figure65
1.Knob(reel-speedcontrol)
3.Rposition
2.Handle(backlaplever)
4.Fposition
5.Rotatethereel-speedknobtosetting1(Figure
65).
6.Starttheengineandrunatlowidlespeed.
Important:Donotchangetheenginespeed
whilebacklappingorthereelsmaystall.
Onlybacklapatidleenginespeed.
7.Withthemow/transportleverintheNEUTRAL
position,movetheraise/lowermowcontrol
forwardtostartthebacklappingoperationonthe
reel.
8.Applylappingcompoundwithalonghandle
brush.Neveruseashort-handledbrush.
•Ifthereelsstallorbecomeerraticwhile
backlapping,selectahigherreelspeed
settinguntilthespeedstabilizes,thenreturn
thereelspeedtosetting1ortoyourdesired
speed.
•Tomakeanadjustmenttothecuttingunits
whilebacklapping,turnthereelsoffby
movingtheraise/lowermowcontrolrearward
andshutofftheengine.Aftercompleting
adjustments,repeatsteps4through8.
9.Repeatthesteps4through8forallcuttingunits
thatyouwanttobacklap.
10.Whennished,returnthebacklaplevertothe
Fposition,movethereelspeedknobtothe
desiredreel-speedsetting,lowertheseat,and
washalllappingcompoundoffofthecutting
units.Adjustcuttingunitreeltobedknifeas
needed.
Important:Ifyoudonotreturnthebacklap
levertotheFpositionafterbacklapping,
thecuttingunitswillnotraiseorfunction
properly.
48