Power Source
1. Turn off the power at the power source location and place the controller’s power switch to OFF. Connect and route
the appropriate size 3-conductor cable (14 AWG [2.5mm2] maximum) from the power source to the controller
pedestal.
The provided power cable access hole can accommodate a 1" (25mm) conduit fitting. If conduit is required, install a
section of flexible 1" (25mm) electrical conduit from the power source conduit box to the pedestal’s access hole.
2. Strip the power cables and secure them to the terminal block. Reference Table 1 and Figure 7 for the appropriate
type of power connection.
3. Reinstall the power supply cover.
4. Apply power to the controller.
WARNING!
AC POWER WIRING MUST BE INSTALLED AND CONNECTED BY QUALIFIED PERSONNEL ONLY.
ALL ELECTRICAL COMPONENTS AND INSTALLATION PROCEDURES MUST COMPLY WITH ALL
APPLICABLE LOCAL AND NATIONAL ELECTRICAL CODES. SOME CODES MAY REQUIRE A MEANS
OF DISCONNECTION FROM THE AC POWER SOURCE, INSTALLED IN THE FIXED WIRING, HAVING
A CONTACT SEPARATION OF AT LEAST 3mm IN THE LINE AND NEUTRAL POLES.
ENSURE THE AC POWER SOURCE IS OFF PRIOR TO SERVICING. FAILURE TO COMPLY MAY
RESULT IN SERIOUS INJURY DUE TO ELECTRICAL SHOCK HAZARD.
9
Lynx® SmartHub Installation and User Guide
Figure 7
To Next Page
Loading...
Need help?
General
