Toro Multi Pro 5800 - Installing the Rate Control Manifold Valve; Installing the Agitation Manifold Valve

InstallingtheRateControlManifold
Valve
1.Aligna1gasketbetweentheangesoftheratecontrol
valvemanifoldandthepressurelterhead(AofFigure
96).
Note:Ifneeded,loosenthemountinghardwarefor
thepressurelterheadasneededtoprovideclearance.
Figure96
1.Locknut
5.Gasket9.Manifoldvalve
assembly
2.Valvemount
6.Clamp10.Socket(outlet
tting)
3.Flange
(agitation
valve)
7.Flange
(pressurelter
head)
11.Retainer
4.Flanged-head
bolt
8.Flange(rate
controlvalve)
2.Assembletheratecontrolvalvemanifold,gasket,and
pressurelterheadwithaclamptightenedhandtight
(AofFigure96).
3.Aligna1gasketbetweentheangesoftheratecontrol
valveandtheagitationvalvemanifold(AofFigure96)
4.Assembletheratecontrolvalvemanifold,gasket,and
agitationvalvemanifoldwithaclamptightenedhand
tight(AofFigure96).
5.Assembletheratecontrolvalvetothevalvemountwith
the2anged-headboltsand2angedlocknuts(Aof
Figure96)thatyouremovedinstep3ofRemovingthe
RateControlManifoldValve(page62)andtorquethe
nutandboltto1017to1243N-cm(90to110in-lb).
6.Assembletheoutletttingontothelowerendcap
ttingofthemanifoldvalve(BofFigure96).
7.Securetheendcapttingtotheoutletttingby
insertingaretainerintothesocketoftheoutlettting
(BofFigure96).
8.Ifyouloosenedthemountinghardwareforthe
pressurelterhead,tightenthenutandboltto1978to
2542N-cm(175to225in-lb).
InstallingtheAgitationManifoldValve
1.Aligntheangeoftheagitationvalvemanifold,1
gasket,andtheangeoftheagitationbypassvalve(A
ofFigure97).
Note:Ifneeded,loosenthemountinghardwarefor
themasterboomvalveasneededtoprovideclearance.
67