Toro Power Max - Page 57

8-5Power Max Service Manual
NON-WHEEL CLUTCH
TRACTION DRIVE SYSTEM
Fig 110 MVC-1004X.jpg
13. Remove the snap ring from both ends of the pulley
pivot assembly shaft (Fig. 110). The nylon bushings
can be removed now or when the pulley pivot
assembly is removed.
14. Reach up to the far left corner of the pulley pivot
assembly and unhook the spring from the pivot
assembly (Fig. 111).
Fig 111 MVC-1005X.jpg
15. Slip the belt off of the pulley and slide the pivot
assembly to the side to remove the rod ends from
the side plate (Fig. 112).
Fig 112 MVC-1007X.jpg
Fig 113 MVC-870XB.jpg
16. To separate the pulley from the pulley pivot
assembly use a box end wrench and screwdriver to
loosen the nut (Fig. 113).
A
A. Snap Ring
A. Spring B. Pivot Assembly
A
B
A. Pivot Assembly
A