9-24 Power Max Service Manual
WHEEL CLUTCH
TRACTION DRIVE SYSTEM
15. Apply a light coat of anti seize to the 11-tooth gear
(Fig. 204). Repeat the process for the opposite side.
Fig 204 MVC-035X.jpg
16. Assembly can now go back into housing (Fig. 205).
Fig 205 MVC-1905X.jpg
Refer to the drive system reassembly procedure, beginning
with step 17 on page 9-14.
After installation into the housing, rotate left and right
collars fully to the stop. Ensure that the mechanism
operates smoothly. Check each of the 6 pawls to ensure
that it returns fully when the shift collar is released. (A
non-returning pawl indicates binding or missing parts).
To Next Page
Loading...
