10-2 Power Max Service Manual
DISCHARGE CHUTE
Fig 211 MVC-804X
6. There is a ring on the base of the chute that is
secured with three screws (Fig. 211).
Fig 210 MVC-885X
5. Lift the chute and defl ector off of the auger cover
(Fig. 210).
7. If necessary the defl ector can be separated from the
chute by removing the hinge (Fig. 212).
Fig 212 MVC-807X
8. The last chute component is the chute guide. It is
attached to the auger cover with one screw in front
and tabs on the rear (Fig. 213).
Fig 213 MVC-891X
To Next Page
Loading...
