Overview of the Virtual Pedal Stop (VPS) Feature
(continued)
G462150s
Indicates the maximum traction speed (pedal stop)
This speed is locked out under the protected PIN
menu.
• This feature allows you to customize the speed settings for your comfort level, or to
customize the speed settings to fit the application.
• Whenever the maximum traction speed is changed via the supervisor maximum speed
settings or Virtual Pedal Stop, the traction pedal is automatically reprogrammed to use
the full pedal stroke between neutral and the new maximum speed. This means the
operator gains more precise control of the traction speed at lower maximum speed
settings.
Tips for Using Virtual Pedal Stop (VPS)
• Set the max speed temporarily lower for mowing the cleanup pass on the fairway.
• Set the max speed temporarily lower for improved control operating in or near the
maintenance shop.
• Set the max speed temporarily lower for improved control loading the machine onto a
trailer.
Cruise Control
Cruise Control Operation
G461475
The cruise-control switch locks in the cruise
control to maintain the desired ground speed.
Pressing the rear of the switch turns the cruise
control off, the middle position of the switch
enables the cruise-control function, and the front of
the switch sets the desired ground speed.
After the cruise control switch is enabled and the
speed is set, use the InfoCenter display to adjust
the speed setting of the cruise control.
To disengage the cruise control use the following:
3464-478A Page 5–18 Operation: During Operation
To Next Page
Loading...
