Toro Reelmaster 5010- H - Servicing the Fuel Filter

Servicing the Fuel/Water Separator (continued)
Replacing the Fuel/Water Separator Filter
1. Replace the filter as shown.
G452996
2. Prime the filter and the lines to the high pressure pump.
Servicing the Fuel Filter
1. Tilt the seat open.
2. Remove the floor plate by removing the 4 bolts securing it to the machine.
3. Clean the area around the fuel filter hose connections.
Note: Use a clean cloth to clean hose connections.
4. Move the clamps that secure the hoses to the fittings of the fuel filter and remove the
hoses from the fittings.
5. Align a drain pan under the filter and remove the filter.
3464-478A Page 6–20 Maintenance: Fuel System Maintenance