Overview of the Acceleration Mode
This feature determines how quickly the machine changes traction speed when the traction
pedal is not in the N
EUTRAL position.
Note: If you take your foot off the traction pedal, allowing it to return to the NEUTRAL position
while the machine is moving, the braking profile is engaged. The braking profile is always
the same and cannot be customized by the acceleration mode feature.
Enter the protected menus on the InfoCenter display to change the acceleration mode. The
acceleration mode has the following 3 positions:
• L
OW—least aggressive acceleration and deceleration
• M
EDIUM (default)—medium acceleration and deceleration
• H
IGH—most aggressive acceleration and deceleration
Overview of the Warm-Up Mode
When starting the machine in cold weather, warm-up mode limits the engine speed to low
idle for a short period after the engine is started, preventing potential component damage
from operating the machine with cold oil.
A snowflake icon on the display screen denotes when warm-up mode is active. Do not
operate the machine until after the warm-up period.
Overview of Toro Smart Power™
With Smart Power, the operator does not have to listen to the engine speed in heavy load
conditions. Smart Power prevents the engine from bogging down in heavy cutting conditions
by automatically controlling the machine speed and optimizing cutting performance.
Note: By default, the Smart Power feature is ON.
Starting the Engine
IMPORTANT
You must bleed the fuel system before starting the engine if you are starting the
engine for the first time, the engine has shut off due to lack of fuel, or you have
performed maintenance on the fuel system; refer to Bleeding the Fuel System, page
6–22.
1. Sit on the seat, keep your foot off the traction pedal so that it is in N
EUTRAL, engage the
parking brake, and ensure that the PTO switch is not engaged.
2. Turn the key to the O
N/PREHEAT position.
An automatic timer controls the glow plug preheat for 6 seconds.
3. After preheating the glow plugs, turn the key to the S
TART position.
3464-478A Page 5–20 Operation: During Operation
To Next Page
Loading...
