Page 5 – 6
Electrical System
Sand Pro & Infield Pro 3040/5040
General Run Problems (Continued)
Problem Possible Causes
Battery does not charge. Wiring to charging circuit components is loose,
corroded or damaged (see Wiring Schematics in
Chapter 7 – Electrical Diagrams).
Voltage regulator is not grounded or is faulty.
Alternator stator is faulty.
Fuse F1 (15 amp) is open, loose or missing.
Charge relay is faulty.
Fusible link to starter solenoid is open.
Ignition switch is faulty.
Battery is discharged or faulty.
To Next Page
Loading...