Toro Sand Pro 5040 - Hydraulic Tank

Page 4 – 38Hydraulic System
Sand Pro & Infield Pro 3040/5040
Hydraulic Tank
1. Cap
2. O–ring
3. Dipstick
4. Hydraulic tank
5. O–ring
6. O–ring
7. Bushing
8. Vent fitting
9. Hose
10. Tank clamp
11. Flat washer
12. Tank clamp
13. Plug
14. Washer head screw (2 used)
15. Filter bracket
16. Cap screw (2 used)
17. Lock washer (2 used)
18. Hydraulic fitting
19. Oil filter head
20. Oil filter
21. Hydraulic 90
o
fitting
22. Cap screw
23. Flange nut
24. Plug
25. Hose clamp
26. Suction hose
27. Hydraulic fitting
28. Suction hose
Figure 30
FRONT
RIGHT
2
3
4
24
21
18
19
22
1
23
25
26
21
27
16
17
14
20
15
11
22
11
25
11
22
5
6
7
8
9
10
12
13
5
5
6
2
12
25
28
Removal (Fig. 30)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
2. Remove two (2) cap screws and flat washers that se-
cure center shroud to machine (Fig. 31). Lift center
shroud from frame.
3. Place drain pan under hydraulic oil filter. Make sure
that drain pan is large enough to hold hydraulic tank con-
tents (5 gallons/18.9 liters).
4. Remove hydraulic oil filter from filter head to allow
hydraulic tank to drain.