Page 5 – 2
Electrical System
Sand Pro & Infield Pro 3040/5040
Electrical Schematic and Drawings
The electrical schematic, circuit diagrams and wire har-
ness drawings for the Sand Pro and Infield Pro are lo-
cated in Chapter 7 – Electrical Diagrams.
Special Tools
Multimeter
The multimeter can test electrical components and cir-
cuits for current (amps), resistance (ohms) or voltage.
Obtain this tool locally.
NOTE: Toro recommends the use of a DIGITAL Volt–
Ohm–Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
Figure 1
Skin–Over Grease
Part Number: 505–165
Special non–conductive grease which forms a light pro-
tective skin to help waterproof electrical switches and
connections.
Figure 2
To Next Page
Loading...