Sand Pro & Infield Pro 3040/5040 Page 4 – 17 Hydraulic System
Hydraulic Test Fitting Kit
Part Number: TOR4079
The test fitting kit includes a variety of O–ring Face Seal
fittings to enable the connection of test gauges into the
system.
The kit includes: tee’s, unions, reducers, plugs, caps
and male test fittings.
Figure 10
TORO TEST FITTING KIT (TOR4079)
Measuring Container
Part Number: TOR4077
Use this graduated container for doing hydraulic motor
efficiency testing (motors with case drain lines only).
Measure efficiency of a hydraulic motor by restricting the
outlet flow from the motor and measuring leakage from
the case drain line while the motor is pressurized by the
hydraulic system.
The table in Figure 12 provides gallons per minute
(GPM) conversion for measured milliliter or ounce leak-
age.
Figure 11
Figure 12
Hydraulic
System
To Next Page
Loading...