Toro Sand Pro 5040 - Lift Control Valve

Page 4 – 48Hydraulic System
Sand Pro & Infield Pro 3040/5040
Lift Control Valve
1. Hydraulic hose
2. Hydraulic hose
3. Hydraulic tube
4. O–ring
5. Guide plate
6. Lock nut (3 used)
7. Knob
8. Lever
9. Lock nut (2 used)
10. Lift control valve
11. Pivot bracket
12. Offset link assembly
13. O–ring
14. Cap screw (3 used)
15. Cap screw (2 used)
16. Pivot
17. Curved washer
18. Roll pin
19. Flat washer (2 used)
20. Flange head screw (2 used)
21. Hydraulic tube
22. O–ring
23. Hydraulic 90
o
fitting
24. O–ring (2 used)
25. Hydraulic fitting (2 used)
26. Hydraulic tee fitting
27. Hydraulic hose
28. Hydraulic tube
Figure 40
FRONT
RIGHT
90 to 110 in–lb
(10.2 to 12.4 N–m)
7
5
20
19
16
17
14
6
15
25
11
8
9
23
18
21
12
10
2
1
22
24
4
13
3
13
26
4
23
4
13
28
SAND PRO/INFIELD
PRO 5040
SAND PRO/INFIELD
PRO 3040
27
Removal (Fig. 40)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
2. Remove console from machine to allow access to lift
control valve (see Console Removal in the Service and
Repairs section of Chapter 6 – Chassis).
3. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
4. Thoroughly clean hydraulic hose ends and fittings on
lift control valve to prevent hydraulic system contamina-
tion.