Page 1 – 4
Safety
Sand Pro & Infield Pro 3040/5040
Jacking Instructions
When changing attachments, tires or perform-
ing other service, use correct blocks, hoists
and jacks. Make sure machine is parked on a
solid level floor such as a concrete floor. Prior
to raising the machine, remove any attach-
ments that may interfere with the safe and
proper raising of the machine. Always chock
or block wheels. Use jack stands or solid
wood blocks to support the raised machine. If
the machine is not properly supported by
blocks or jack stands, the machine may move
or fall, which may result in personal injury.
CAUTION
Use the following positions when jacking up the ma-
chine:
Front End Jacking
1. Jack the front of the machine from the bottom of the
frame behind the front wheel (Fig. 1). Make sure that
jack is positioned directly under frame to prevent dam-
age to oil cooler.
Rear End Jacking
1. Jack the rear of the machine from below the wheel
motor (Fig. 2).
1. Front wheel 2. Front jacking point
Figure 1
1
2
1. Rear wheel motor 2. Rear jacking point
Figure 2
1
2
Safety and Instruction Decals
Numerous safety and instruction decals are affixed to
the Sand Pro and Infield Pro. If any decal becomes illeg-
ible or damaged, install a new decal. Part numbers for
replacement decals are listed in your Parts Catalog. Or-
der replacement decals from your Authorized Toro Dis-
tributor.
To Next Page
Loading...