Toro Sand Pro 5040 - Engine; Engine Removal

Gasoline Engine Page 3 – 10 Sand Pro & Infield Pro 3040/5040
Engine
Figure 9
1. Muffler shield
2. Negative battery cable
3. Engine
4. Hose clamp (2 used)
5. Engine support
6. Cap screw (4 used)
7. Engine mount (4 used)
8. Front mount bracket (2 used)
9. Flange nut (4 used)
10. Cap screw
11. Flange nut
12. Engine mount
13. Cap screw (4 used)
14. Lock washer
15. Cap screw (4 used)
16. Crankshaft cover
17. Cap screw (2 used)
18. Breather tube
19. Intake gasket
20. Flange head screw (3 used)
21. Flat washer (4 used)
22. Hose
23. Flange head screw (4 used)
24. Washer head screw (4 used)
25. Gasket (2 used)
26. Muffler
27. Intake elbow
28. Tail pipe
29. Flat washer (4 used)
30. Cap screw (3 used)
31. Flange head screw (4 used)
32. Exhaust gasket (2 used)
33. Flat washer (3 used)
34. Flange nut (3 used)
35. Exhaust shield
FRONT
LEFT
170 to 200 in–lb
(19.2 to 22.6 N–m)
60 to 65 in–lb
(6.8 to 7.3 N–m)
35
24
1
26
16
17
11
5
12
29
13
7
8
9
15
3
6
28
11
10
22
20
21
31
32
34
33
30
23
25
27
19
18
11
15
2
11
14
4
Engine Removal (Fig. 9)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
2. If engine is to be disassembled, it may be easier to
drain oil from engine before removing engine from ma-
chine (see Operator’s Manual).
3. Chock wheels to prevent the machine from moving.