Toro Sand Pro 5040 - Service and Repairs; Front Wheel

Chassis Page 6 – 4
Sand Pro & Infield Pro 3040/5040
Service and Repairs
Front Wheel
1. Wheel motor
2. Lock nut
3. Wheel hub
4. Lock nut
5. Spindle
6. Front wheel
7. Lug nut
8. Cap screw
9. Flangette
10. Flangette
11. Bearing
12. Flange nut (3 used)
13. Bearing tab
14. Flange nut (2 used)
15. Socket head screw (2 used)
16. Hydraulic fitting
17. Hydraulic tube
18. Hydraulic tube
19. Tube clamp
20. Cover plate
21. Cap screw
22. O–ring
23. Hydraulic hose
24. Hydraulic hose
25. O–ring
26. Wheel weight adapter (SP/IP 3040)
27. Wheel weight stud (SP/IP 3040)
28. Wheel weight (SP/IP 3040)
29. Thrust washer (SP/IP 3040)
30. Hose guide
31. Cap screw (2 used)
32. Grease fitting
33. Set screw
Figure 2
FRONT
RIGHT
45 to 55 ft–lb
(61 to 75 N–m)
90 to 120 in–lb
(10.2 to 13.6 N–m)
1
2
3
4
5
6
7
2
17
18
19
20
21
16
15
14
31
30
10
11
9
13
12
8
8
22
22
22
23
24
25
28
29
26
27
32
16
22
25
Loctite #242
45 to 55 ft–lb
(61 to 75 N–m)
33
Removal (Fig. 2)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch. Chock rear wheels to prevent machine
from moving during front wheel removal.
2. Loosen set screw on the bearing locking collar.
3. Support front of the machine. Remove three cap
screws and lock nuts securing the flangettes and bear-
ing tab to the castor fork.
4. Remove cap screw, cover plate and lock nut that se-
cure hydraulic tube clamps to castor fork.