Toro Sand Pro 5040 - Oil Cooler

Page 4 – 40Hydraulic System
Sand Pro & Infield Pro 3040/5040
Oil Cooler
1. Cap screw (4 used)
2. Flange nut (4 used)
3. Lift control valve
4. Steering control valve
5. Fan shroud
6. Tee fitting
7. 90
o
hydraulic fitting
8. Hydraulic tube
9. Oil cooler
10. Rubber clamp (2 used)
11. Flat washer (2 used)
12. Cap screw (2 used)
13. Hydraulic hose
14. O–ring
15. O–ring
16. Hydraulic tube
Figure 32
2
3
4
1
12
16
5
11
15
14
13
10
9
6
7
8
14
15
FRONT
RIGHT
SAND PRO/INFIELD PRO 5040 SHOWN
Removal (Figs. 32 and 34)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
2. Remove two (2) cap screws and flat washers that se-
cure center shroud to machine (Fig. 33). Lift center
shroud from frame.
3. Thoroughly clean hydraulic hose ends and fittings on
oil cooler to prevent hydraulic system contamination.
Label hydraulic connections for assembly purposes.
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
4. Disconnect hydraulic lines from fittings on oil cooler.
Allow hoses to drain into a suitable container.