ChassisPage 6 – 17
Sand Pro & Infield Pro 3040/5040
Removal (Fig 10)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
2. Remove attachment from machine.
3. Remove three (3) washer head screws that secure
rear cover to machine. Remove rear cover.
4. Remove hitch adapter from machine:
A. Support hitch adapter to prevent it from falling
during removal.
B. Remove two (2) washer head screws (item 10)
that secure pins (item 9) to hitch adapter. Pull pins
from hitch adapter and hitch tube.
C. Remove one (1) cotter pin from clevis pin (item 6)
that secures top of hitch adapter to roller plate. Pull
cotter pin from hitch adapter and roller plate.
D. Remove hitch adapter from machine.
5. If hitch tube is to be removed from machine, remove
one (1) cotter pin from cylinder pin (item 16) that secures
lift cylinder to hitch tube. Slide cylinder pin from hitch
tube and lift cylinder.
6. Remove remaining hitch assembly components
from machine as needed using Figure 10 as a guide.
7. If required, remove bushing(s) from hitch tube (Fig.
11) and/or roller tube.
Installation (Fig 10)
1. If expansion plug was removed from hitch tube,
press plug into tube so outer edge of plug is 1.690” (42.9
mm) from outer surface of hitch tube (Fig. 11).
2. If bushings were removed from hitch tube and/or roll-
er tube, install removed bushing(s).
3. Install all removed hitch assembly components us-
ing Figure 10 as a guide.
4. Lubricate hitch assembly grease fittings.
5. Install attachment to machine.
1. Hitch tube
2. Expansion plug (2 used)
3. Flange bushing (2 used)
4. Flange bushing (4 used)
Figure 11
EXPANSION PLUG
LOCATION
2
3
4
1
1.690”
(42.9 mm)
2
3
1
Chassis
To Next Page
Loading...